Broken Garage Door Cable NJ

If this is the first time you’ve dealt with a broken garage door cable it will show foreign symptoms for your door. It is important to know the function of the cable, what they are made out of, why they are needed, and how to fix the issue. First and most important knowing the function of a garage door cable will make you better understand how much of an important part they are. Rather, every garage door has some type of “lift cables” which are made of galvanized wire. There are sometimes better know as aircraft cables.

Nonetheless, they are very strong as their function is to lift the garage door as the springs and openers function the doors movement. Each door contains two cables one for each side of the door. It attaches to the bottom of the door and then routed to the spring system as required by the type of counterbalance on your doors.

Is it the same as a garage door safety cable?

When installed properly garage door cables have a secondary use. Rather, they are called “retaining cables” when used as a safety protocol. The retaining cables are inserted inside the spring system as a secondary safety measure in case the springs snap. Consequently, this would stop the spring from flying in event of breakage.

Why did my garage door cables break?

A question many ask is why did my garage cable break? These cables move and operate every time the garage door is opened or closed. The way they move depends on the spring system that you have installed. If it is an extension spring they are wound over a pulley system. When you have a torsion spring it is over a cable drum. Pulleys and drums are located toward the top of the door to help it lever the garage door up. Over time your garage door cables start to deteriorate from external forces. Moisture on your garage floor can cause the metal to soften up. Faulty bearings on your pulleys can cause extra wear and tear. Corrosion, rust, or excessive wear and tear will also cause it to break.

How do I fix my garage door cables?

More so than not homeowners are unaware that the problem is from the garage door cables. You might enter your garage and see a wire hanging from a strand of metal. As mentioned above the signs of corrosion, rust or excessive wear should be handled before the cables snap or break. Furthermore, Handyman Garage Doors never recommends trying to fix a cable on your own. They hold a lot of the weight of the door and have the whole mechanism attached to them. These have to be uninstalled and reinstalled correctly or it can become a big safety hazard. A trained technician can evaluate the door system and replace the parts as needed.

Homeowners can evaluate a problem for themselves before it escalates. Does your door shake, struggle or make funny noises? Do the cables, drums or pulleys show signs of wear and tear? Do you see any corrosion or rust? Call a Handyman Garage Doors expert to help you with your garage door cables before it turns into a bigger problem. We offer services for all cables, pulleys, tracks, rollers, bearings and spring systems. 1-800-326-8140

Pulleys System: Extension Springs

Extension spring systems use a pulley and cable lever to pull the door up and down. One of the major failures of garage doors using extension springs are pulleys going bad. The ball bearing within the pulley breaks down and start to scrape against the tracks they are placed on or the rivets fall and pulley splits. Homeowners facing pulley problems usually complain of the door opening half way and stopping. It also would sit uneven on the garage floor exposing a crack or space. When the door tries to get reopened it usually jams.

Another symptom is a scraping sound and the door having a binding or sticking feeling when opening it. If attempting to DIY replace garage door pulleys always make sure the garage door is opened as it unwinds the extension springs. Handyman Garage Doors recommends calling an expert technician fix the pulleys and restoring your garage doors functionality.

Cable Drums: Torsion System

On the contrary to the pulleys garage door torsion springs contain cable drums. A drum is a circular roller with grooves that is placed on the shaft of the torsion spring system. The cables are wrapped around the drums and to the bottom of the door. When the torsion spring winds or unwinds it causes the drums to make a circular motion which pulls the cables up and down. Nonetheless, this causes the door to get lifted or lowered. Consequently, because these drums are attached to torsion springs, if they are a cause for issue they must be fixed right away for your safety. A symptom of a broken garage door drum is the door hanging on one side. This fix requires a trained and experienced garage door technician. Call Handyman Garage Doors today at 1-800-326-8140

NJ Licence

13VH10165400

Broken Garage Door Cable NJ

If this is the first time you’ve dealt with a broken garage door cable it will show foreign symptoms for your door. It is important to know the function of the cable, what they are made out of, why they are needed, and how to fix the issue. First and most important knowing the function of a garage door cable will make you better understand how much of an important part they are. Rather, every garage door has some type of “lift cables” which are made of galvanized wire. There are sometimes better know as aircraft cables.

Nonetheless, they are very strong as their function is to lift the garage door as the springs and openers function the doors movement. Each door contains two cables one for each side of the door. It attaches to the bottom of the door and then routed to the spring system as required by the type of counterbalance on your doors.

Is it the same as a garage door safety cable?

When installed properly garage door cables have a secondary use. Rather, they are called “retaining cables” when used as a safety protocol. The retaining cables are inserted inside the spring system as a secondary safety measure in case the springs snap. This would stop the spring from flying in event of breakage.

Why did my garage door cables break?

A question many ask is why did my garage cable break? These cables move and operate every time the garage door is opened or closed. The way they move depends on the spring system that you have installed. If it is an extension spring they are wound over a pulley system. When you have a torsion spring it is over a cable drum. Pulleys and drums are located toward the top of the door to help it lever the garage door up. Over time your garage door cables start to deteriorate from external forces. Moisture on your garage floor can cause the metal to soften up. Faulty bearings on your pulleys can cause extra wear and tear. Corrosion, rust, or excessive wear and tear will also cause it to break.

How do I fix my garage door cables?

More so than not homeowners are unaware that the problem is from the garage door cables. You might enter your garage and see a wire hanging from a strand of metal. As mentioned above the signs of corrosion, rust or excessive wear should be handled before the cables snap or break. Furthermore, Handyman Garage Doors never recommends trying to fix a cable on your own. They hold a lot of the weight of the door and have the whole mechanism attached to them. These have to be uninstalled and reinstalled correctly or it can become a big safety hazard. A trained technician can evaluate the door system and replace the parts as needed.

Homeowners can evaluate a problem for themselves before it escalates. Does your door shake, struggle or make funny noises? Do the cables, drums or pulleys show signs of wear and tear? Do you see any corrosion or rust? Call a Handyman Garage Doors expert to help you with your garage door cables before it turns into a bigger problem. We offer services for all cables, pulleys, tracks, rollers, bearings and spring systems. 1-800-326-8140

Pulleys System: Extension Springs

Extension spring systems use a pulley and cable lever to pull the door up and down. One of the major failures of garage doors using extension springs are pulleys going bad. The ball bearing within the pulley breaks down and start to scrape against the tracks they are placed on or the rivets fall and pulley splits. Homeowners facing pulley problems usually complain of the door opening half way and stopping. It also would sit uneven on the garage floor exposing a crack or space. When the door tries to get reopened it usually jams.

Another symptom is a scraping sound and the door having a binding or sticking feeling when opening it. If attempting to DIY replace garage door pulleys always make sure the garage door is opened as it unwinds the extension springs. Handyman Garage Doors recommends calling an expert technician fix the pulleys and restoring your garage doors functionality.

Cable Drums: Torsion System

On the contrary to the pulleys garage door torsion springs contain cable drums. A drum is a circular roller with grooves that is placed on the shaft of the torsion spring system. The cables are wrapped around the drums and to the bottom of the door. When the torsion spring winds or unwinds it causes the drums to make a circular motion which pulls the cables up and down. Nonetheless, this causes the door to get lifted or lowered. Consequently, because these drums are attached to torsion springs, if they are a cause for issue they must be fixed right away for your safety. A symptom of a broken garage door drum is the door hanging on one side. This fix requires a trained and experienced garage door technician. Call Handyman Garage Doors today at 1-800-326-8140

NJ Licence

13VH10165400